威尼斯在线平台-澳门威尼斯在线登录-官网

Welcome to the official website of Wuxi heavy industry micro bearing factory!
NEWS
POSITION:HOME > EN > NEWS >
Outside the spherical bearing 2016/11/18
Although its basic performance with deep groove ball bearings should be similar, but because of the bearing are mostly applied in mechanical rough, installation location is not accurate, the axis of the shaft with a hole to neutral, or unde...
A brief introduction of non-standard bearings 2016/11/18
The non-standard bearings, popular, is not conform to the requirement of national standard dimension of bearing, that the dimensions is different from all the bearing of national standard. Its main characteristic is, low degree of generalit...
Non-standard bearing rust prevention methods 2016/11/18
Surface cleaning: 1, surface cleaning: cleaning must be rust in accordance with the nature of the surface and the conditions, select the appropriate method. There are usually used solvent cleaning, chemical cleaning and mechanical cleaning....
The characteristics of the flange bearing 2016/11/18
Flange bearing the biggest characteristic is to the flange and the bearing. When one end of the shaft is not fitting, needs to be fixed on the plane, such as plate, wall, flange bearing it reflects its advantages. In ultra small aperture in...
Flange bearing of the main purposes 2016/11/18
Flange bearing is suitable for all kinds of industrial equipment, small rotary motor, office equipment, micro motor soft, pressure rotor, dental drill, hard disk drive motor, stepping motor, VCR magnetic drum, toy models, fan, roller, rolle...

威尼斯在线平台|澳门威尼斯在线登录

XML 地图 | Sitemap 地图